Ukronics_Pariza_BOOT_64K



THIS IS FOR ALREADY CONVERTED ARIZAS ONLY

*NOTE*
do not attempt to install this into an original ariza as it will render it dead and will need to be jtagged to bring it back to life

*NOTE*
if march 9 conversion was already jtagged into the converted unit ...this flash DO NOT need to be installed .....it was preinstalled into the jtag flash

this is to load the JTAG factory Flash Using serial cable ( this WILL NOT convert ariza to pariza)

install this boot to get hyperterminal to show up on a previously converted ariza

load it with loader included in zip

setup hyperterminal as per instructions in new conversion posted in converted ariza discussion area






then open hyperterminal connection ...Hook up Pariza with serial cable ....start receiver and load JTAG factory flash file 2 MB located in march 9 2009 conversion package by pressing (e) on keyboard as instructed


then you can load the jtag 2mb flash any time to bring the unit back to life without jtagging

then load the latest working bin
and your good to go

thanks to ukronics


new JTAG FLASH posted




posted a new conversion since the other was a bit old

located here



this is the flash pulled out of my receiver
for those having problems With PARIZA NFLD BG bins
i suggest you JTAG this flash into your receiver
This is the flash these bins are tested on

once jtagged by parrallel port for first time(AND I STATE IT HAS TO BE LOADED THE FIRST TIME THROUGH JTAG_PARALLEL PORT)
after that it can be loaded back into pariza as a factory flash with hyperterminal using the 2 mb option through serial cable ...
i loaded this flash thats posted in the conversion this way ..and has worked as a factory flash every time

*note *
after doing this use factory setting before setting up and scanning satellites


So you can Basically call it a JTAG FLASH initially through parallel then after can call it a Factory Flash through serial with hyperterminal

then after load latest pariza bin released



hope it helps those with issues